Jewellery Stand

The Jewellery Stand is an original design by Yannic Fréson 3D: a three-part screen for a dresser, with room for 30 pairs of earrings, hoops and 8 necklaces. The middle panel and two angled side panels are Ivory White matte PLA with rose gold bars and lines in silk PLA. A tray for bracelets hangs at the front.

Three-panel jewellery stand in Ivory White with Rose Gold bars on a white bedroom dresser in morning sun, hung with earrings and necklaces and with bracelets in its tray, beside a lamp, a bud vase and perfume

About this design

The Jewellery Stand was made to show earrings, not to put them away. The question was how a rack for thirty pairs can look elegant and still be sturdy enough to be handled every day.

The design. The stand is a screen in three parts. The middle panel has windows with rose gold bars: at the top a Ø 4 mm rod for hoops, below it four bars 3 mm thick and 14 mm high with Ø 1.8 mm holes, five pairs to a bar. Within a pair the holes are 23 mm apart, between two pairs 31 mm. A hole does not sit in the middle of its bar: it sits lower, with 0.75 times as much space below the hole as above it. Two side panels stand 34.4 degrees forward on rose gold hinge pieces. Each has two short bars for small earrings and a rail with four hooks for necklaces. There are no round or arched outlines, only 45 degree chamfers, and the rose gold lines on the ivory always run in pairs.

What makes it hard. The middle panel is 316 × 364 mm and does not fit a 256 mm build plate. So the stand is made of 60 parts, none longer than 320 mm, the longest lying diagonally across the plate. The bars, the rod and the rails sit in closed mortises with 0.15 mm of play on each side: they are glued, and they are held even without the glue. The necklace hooks are square, 2.8 mm in a 2.9 mm hole, so they can only be glued in straight. The colours follow a rule. Silk PLA shows the print direction on every flat face, so rose gold goes to slim parts that lie with their visible faces as walls. Ivory goes to the broad parts, printed front down on the textured plate, so every front has the same finish.

The tray. A tray with a dune inside and a rose gold line in its rim hangs at the front. It hooks into the bottom rail with two dovetails and lifts out upwards. Its bottom 6 mm is printed solid, because the tray is also the counterweight: with it on, the stand only tips back after 12.3 degrees. Thirty pairs of earrings weigh very little, but a rack that falls over rarely does so quietly.

It shows what you can ask for: a large piece made of many parts that fit together to the millimetre. If you would like something similar, ask for a quote.

More images

Need something similar?

Every design can be made in other colours, another size or with your own text. Request a quote and you get a fixed price.