Ridge Centrepiece
Ridge is an original design by Yannic Fréson 3D: a centrepiece for a large dining table. A thin sheet of stone rises along an S to an off-centre peak and leans over. On the side it leans towards, the stone is worn through to copper. Ivory White matte PLA with five inlays in copper metallic PLA.

About this design
Ridge is a centrepiece for a large dining table in dark wood. The brief was short: something that catches the eye and looks rugged and natural, in white and copper. Elegant yet natural, raw but fluent.
The design. The shape is a thin sheet of stone that runs across the table along an S. It rises to a peak that is not in the middle, and leans over there, like a ridge where the wind always comes from the same side. On the side it leans towards, the stone is worn away and the copper shows through. The stone is Ivory White matte PLA with a rough, grainy skin; the copper is metallic PLA. The piece is 449 mm long, 152 mm deep and 189 mm high.
What makes it hard. A shape that leans over wants to fall over. So its centre of mass lies low and inside the edge of what rests on the table, and it stands without a foot or a weight. The copper is five inlays about 3 mm thick. Each is glued into a pocket cut straight in from the front, with its upper wall at 45 degrees, the steepest overhang a printer manages without support. The rough skin runs right up to the rim of each pocket, so the seam between stone and copper disappears into the texture. The stone itself is too big for one build plate and is made of two halves, glued on three square pins.
The name. A ridge is the crest of a mountain. The piece says as much on its own, but a name helps when you ask for a quote.
It shows what you can ask for: a decorative piece in a free form, with a second material laid into it rather than painted on. If you would like something similar, ask for a quote.
More images
Need something similar?
Every design can be made in other colours, another size or with your own text. Request a quote and you get a fixed price.